If you have a related question, please click the ” Ask a related question ” button in the top right corner. There was a little communication confusion with Xilinx. However, I don’t see an error in my boot log, and in fact it assigns the PHY id correctly to eth0 and eth1: Registration is quick, simple and absolutely free. I used forcedeth for the driver and all worked fine for most Distros.

Uploader: Yozragore
Date Added: 5 November 2010
File Size: 24.30 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 83813
Price: Free* [*Free Regsitration Required]

Have you tried with slightly rearranged device tree like this? This driver did not appear in the kernel until 2.

DM6467 U-Boot with MARVELL 88E1111 PHY Issue

Introduction to Linux – A Hands on Guide This guide was created as an overview of the Linux Operating System, geared toward new users as an exploration tour and getting started guide, with exercises at the end of each chapter.

I don’t have the Marvell datasheet handy, but recall seeing that when run a 1. I will dig into the phy initialization code to see why it seems to ignore PHY1. This is a real pain since most of Ubuntu installs by the internet. So I would suggest you to try testing the setup in The problem is that it 88e1111 to use the sk98lin driver provided by the vendor syskonnect but the kernel guys decided to replace it with skge in January The device tree in the newer kernels uses the MACB drivers.


I tried it without success.

Solved: Dual Marvell 88e PHY Ethernet problem – Xilinx – Community Forums

The U-boot used is a and the Linux used is the Ti 2. See last few lines below!

My network is Mbit. If you have further questions related to this thread, you may click “Ask a related question” below. There was a little communication confusion with Xilinx.

If they both operate at 2.

Click Here to receive this Complete Guide absolutely free. Thu Feb 18 Find More Posts by mhbell.

So you may be in the same situation as me I have confirmed this as I have the latter card. I’m just using the following default enviroment parameters: Please upgrade to a Xilinx. Now from the EVM board at the u-boot prompt, I can ping other computers successfully and load the kernel. We are not able to run our dual GEM config. Dec 4, I suspect this is a software issue. Join Date Jul Beans 1. Yes, I have tried it, but eth1 still doesn’t work. Join Date Jun Beans Finally, I saw this thread for Petalinux, which I was not able to locate the patch for, but it seems related.


Here are the u-boot commands I used to make this change: I Have met the same problem, hope could get some ideas from you! I had seen that, but we run both PHYs a 1. In reply to Ronald: According to the kernel dev Fabbione the kernel tree driver for hoary sk98lin works for some people and not for others.

TI is a global semiconductor design and manufacturing company.