ZIP, and you must remember to move those patch files into C: Crystal audio chips in the series from CS through CS appear frequently as the integrated audio on motherboards, where they provide Sound Blaster Pro 2. Unable to expand servers Page Directory. Note that registered members see fewer ads, and ContentLink is completely disabled once you log in. They hope these examples will help you to get a better understanding of the Linux system and that you feel encouraged to try out things on your own.

Uploader: Mazusar
Date Added: 17 May 2014
File Size: 66.85 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 89598
Price: Free* [*Free Regsitration Required]

Visit the following links: Make sure the bit DMA channel is correct. Note that your submission may not appear immediately on our site. In another touch of irony, the Windows drivers didn’t even work.

On ayou need to keep one serial port for the mouse. BB code is On.

ISA go Bragh™

Advertisements or commercial links. I am using the default slackware kernel on Unfortunately, the card is not compatible with DN3D. Note also that you need to re-install the alsa-drivers every time you re-compile the 2. It is relatively nice, providing menu-driven configuration of resources, a mixer, and a sound test. It was a non-upgrade that screwed us up for years and from which we never completely recovered.


There is a configurator that works in plain DOS, but it was cleverly hidden inside of the Windows drivers package, which can’t be extracted under DOS. Often it will get wedged and cause driver failures after a warm reboot.

It sometimes gets into a state that garbles OPL3 music and a power cycle is needed crustal reset it. If it’s V, V or V, then you do.

The bass and treble controls even work. In practice, the default and correct answers for these are nearly always, 5, 1, and 5, respectively. However, after initial success it became obvious that some of the instruments are just bad and wrong for music that was tuned for a genuine OPL3.

Installing Crystal B audio driver – antiX oldforums archive

Auudio second DMA channel is used only for full-duplex operation. Despite the prominent MegaImage32 label on the back, I still cannot identify this card with any well-known make and model.

BAT each and every time the card is initialized.

Here we go again. W98SE comes with workable drivers for this card.

Exiting and restarting it with no command-line switches seems to purge the problem, but it recurs. I haven’t yet found a SIMM for it that doesn’t cause problems. ZIP package don’t work any better than the later versions did.


Both 4 and 10 are supported by the hardware, albeit in a more roundabout way than the other IRQs. Thank You for Submitting a Reply,! It’s kind of funny that Advanced Gravis would be years ahead of their time on the other technical capabilities and yet didn’t think that a basic volume control was important.

Also, you may find it necessary to include options in your modprobe statement, even though it suggests trying to load the driver without any options. So what do you do if those resources are already assigned audko other PnP devices? I did not try to guess the resources used when PnP is disabled. Crystal Sound – syslog message Apparently you haven’t recompiled aufio kernel, since this is a fresh install, so don’t worry about reinstalling ALSA.

See the equivalent MPB daughterboard here. Wageningen, the Netherlands Distribution: