HOW TO RESHAFT A CALLAWAY DRIVER DOWNLOAD

0 Comments

Danny makes it look effortless. Any help would be greatly appreciated. If you are trying to save the shaft then use some heat shield liberally on the club especially on the seams, then use a low heat heat gun and alot of patience. I would like to have more details on trimming the shaft and proper tools to use, but it’s a great overview on how simple it is. At this point you still want a snug fit, so just take off enough paint to get the shaft through the head. Choose from a category below. Wipe excess epoxy off the shaft and set aside for a while to allow the plug and ferrule to set.

Uploader: Yozshum
Date Added: 18 March 2013
File Size: 30.13 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 99918
Price: Free* [*Free Regsitration Required]

I look forward to more of this content.

reshafting a Callaway Fthelp please! – WRX Club Techs – GolfWRX

Manufacturers make this mistake quite often as well, I have removed epoxy plugs from tips of OEM built clubs that have been over 3 inches long. Cardio football-player Created with Sketch. Results 16 to 30 of How To Reshaft Golf Clubs. I might have t actually this myself. Last edited by rynobucket; at Javascript Disabled Detected You currently have javascript disabled. Shape Created with Sketch. Keep the club moving back and forth across the face of the wheel so as not to gouge the shaft in one place.

  CONTROL4 LUTRON HOMEWORKS DRIVER DOWNLOAD

What is the best way to pull a shaft from these heads Danny makes it look effortless. It is much easier to manage and negotiate pressure if the shaft is stationary.

How to Cork a Wiffleball Bat. At this point you still want a snug fit, so just take off enough paint to get the shaft hkw the head. In my CS bag: Use the heating gun to to dispense heat evenly at the base of the shaft where it enters the hoow head and the portion of the shaft seen at the sole.

reshafting a Callaway Ft-5…help please!

It’s so informative and worth learning about. Any help would be greatly appreciated.

Last Jump to page: Really fun to watch and learning a lot. You’ll find that attacking the job from several different angles turning the club around will make it easier.

Or easiest to do at home without tools way? Now go to that magic Scotchbrite wheel and slowly and carefully take the bore thru shaft down flush with the sole plate. Put a callawaay quick set epoxy on the shaft, install the ferrule and then insert the shaft in the head until enough sticks out of the sole to rim off properly.

  GP30NB30 MAC DRIVER

Make sure to roughen the plug for better adhesion. GolfWRX – the world’s largest and best online golf community.

G LS Tec 9. So, I ordered another shaft and adapter and did it again. Posted 16 November – Next lightly roughen the shaft tip. While like any other installation you want a light callawayy of epoxy on the shaft, make sure there is a sufficient amount to fill the channel at the top of the club head and under the ferrule. Danny is just the best!

The second time didn’t turn out as well as the first. AND How many of the have a chip paint around the hosel if you are not careful and don’t do it properly? I bookmarked it on my browser.

Please re-enable javascript to access full functionality.