IOLINE 100 DRIVER DOWNLOAD

0 Comments

Don’t have an account? Ioline is not responsible for substandard opera- tional performance as a result of failure to maintain the cutter as described in this User Guide. Page of 29 Go. Ioline suggests an X panel 3. To print the manual completely, please, download it. This The idler pinchwheels have a locking feature that will hold them off of the allows the user to use maximum force 24 lbs. Force values are for starting reference only.

Uploader: Shaktibar
Date Added: 16 November 2017
File Size: 36.49 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 70660
Price: Free* [*Free Regsitration Required]

ikline Slide the paper roll onto a media roller use the roller as an axle. How To Pounce Send Settings temporary or permanent buttons. Ioline Blank – The Blank value is the length, in thousands of an inch milsthat the Force blade will not cut when cutting the segmented line for pouncing or tag board The minimum and maximum force settings for the Force control knob joline the cutout.

This The idler pinchwheels have a locking feature that will hold them off of the allows the user to use maximum force 24 lbs.

Wellington House – Ioline

Led Codes Remove button. The Ioline System Cutter. Drive Shaft – The motor driven shaft that moves material through a friction Acceleration – The rate that a cutter changes the velocity of the carriage or the feed cutter. The cutter will Always observe the following safety precautions: Turn on the cutter while holding down the Test Cut key on the keypad.

  ASUS X59SL BLUETOOTH DRIVER DOWNLOAD

When a stencil is placed on another substrate and paint or ink is applied, the image represented by the cut out portion of the stencil is printed on the substrate below it. It is available from Ioline or an Hold down the Test Cut key until the cutter beeps and the light flashes authorized dealer. Panel- they are covered by material. After you have used the design software to The cutter uses a very sharp blade when cutting. The Calibration Box and Measurements. Learn more about the System and the high-force HF System.

Take the average of the horizontal Y values by adding them together and dividing by 2.

Simply wipe dust and lint off the machine periodically. Select the Start button. Don’t have an account? Changes to the computer operating system or the installation of new peripherals or software might 1.

Ioline 100 User Manual

Refer to the table below for recommended settings for a variety of pen types. Standard serial cables are 3. Ioline Minimum Angle – This is the minimum angle for which the machine will Service Loop – Slack material between the material roll and the cutter. End Notes Ioline or the dealer for technical support.

  C MEDIA CM6206 DRIVER DOWNLOAD

The blades are Adjusting Blade Exposure: Put the cutter in Start mode green LED. Using a hard surface to insert the blade may damage it. Specially engineered parallel-pin driveshaft with a proprietary tread pattern provides a powerful grip on all types of media. Table of Contents Add to my manuals Add. From the menu bar select 1000, Send Cut File.

There’s relatively little to maintain on the System, however extended use without ANY service or preventative maintenance will over time have an effect on the results of the machine. It is the responsibility of the operator of the cutter to follow all safety precautions and warnings that are described in this User Guide.

Scale before and after a cut is completed. Routine Maintenance Prepare the Cutter: Properly adjust blade exposure and force to achieve good cutting results.

Toggle navigation Top Menu.

Ioline Quick Start Manual 4 pages.